Android, Mods

How to Install Viper4Android and Dolby Atmos Android Nougat 7.0 & 7.1.1

How to Install Viper4Android and Dolby Atmos Android Nougat 7.0 & 7.1.1

Viper4Android is a stunning MOD that brings optimizations and enhanced effect to your Android device for better sound experience. Ever since the early stage of the MOD development, it gained a lot of popularity among Android enthusiast because of the features and enhancements it brings. Viper4Android is the perfect MOD for music lovers to get them going.

It is also compatible with the Beats and Dolby Atmos sound MODS with a small little trick. Viper4Android first began the development for Android KitKat and later the developers ported it to the newer version of Android such as Android 5.0.x Lollipop and 6.0.x Marshmallow.

Now, Viper4Android is available for Android 7.0 Nougat or later version. In this article, you are going to learn how to install Viper4Android and Dolby Atmos on Android 7.0 Nougat. It is compatible with most of the stock firmware from numerous manufacturers. So if your device is running Android 7.0 Nougat you can enhance the music experience by installing the Viper4Android mod.

Besides the features it brings, if your phone is running on AOSP and Lineage OS you have a privileged option to flash SonyMusic, Sony Beats, DolbyAtmos and Viper4Android at the same time. So if you are ready to get a new experience on hearing music on your device go ahead and follow the steps below:

Viper4Android Nougat

Warning

Here at DoryLabs, we are not responsible for any good or bad experience you may run into. Remember you are doing this at your own risk and it’s all your responsibilities if you end up breaking up with your girlfriend os simply you delete the chat messages of your crush. Make a backup just in case you want to restore back to the current settings.

Downloads

Download Viper4Android 2.5 for Android 7.0 Nougat

This MOD works perfect in most of the stock firmware but this doesn’t mean it may not fail for some device. So always make a backup of the current files and if possible do a Nandroid backup.

Please Note: The following Mods are compatible only with Android devices running AOSP based ROMs or CyanogenMod, Lineage OS based on Android 6.0 Marshmallow up to Android 7.1.2 Nougat.

To install this MODs you should have a custom recovery such as TWRP installed on your phone. If you haven’t done yet check our custom recovery section.

How to install the MOD

  • DOD and put it into phone internal memory.
  • Turn off your phone and boot into recovery.
  • Make a full Nandroid backup.
  • Go to the install section and flash the MOD.
  • After the phone turns on, configure the options properly.

Open the file manager and go to /root/vendor/etc and rename the audio_effects.conf to audio_effects.conf.bak. Close the File Manager and open Viper4Android. It will ask to download some drivers. Just do it and wait for a while until it installs the drivers. This might take some time. Once it is completed, reboot the device enjoy Viper4Android on Android Nougat.

Related posts

Leave a Reply

Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

WordPress Theme built by Shufflehound. © 2023 All rights reserved by DoryLabs